You are reading help file online using chmlib.com
|
Set Up Your Capture > Capture Options > Timer Setup > Capture Timer Options
Capture Timer Options
The Capture Timer options allow you to set the program to capture screens at predefined times. This is useful, for example, for batch processes that operate on a regular basis and for which screen shots are necessary. Select Tools > Timer Setup and the Timer Setup dialog box opens. To access the Capture Timer options, select the Capture Timer tab.
Note: In timed capture mode, the hide and repeat hotkeys operate. Input and Output options for Capture Timer captures must be set so that the captures can occur unattended. If SnagIt detects a combination of capture options that cannot be used, the status display will indicate "Timer unavailable" and the timer will not start.
Capture Timer Tab OptionsThe following table summarizes the description and use of each option on the Capture Timer tab.
Setting up the Capture TimerThe following step-by-step directions will lead you through the processes of setting up the capture timer.
Select Tools > Timer Setup. The Timer Setup tabbed dialog box opens. Select the Capture Timer tab.
- Select Enable Timer-Activated Capture.
- To remove redundant captures (for example, when the screen does not change for a period of time), select Discard identical captures.
- Specify the frequency of captures in Hours, Minutes, or Seconds (select only one).
- After performing the first capture, SnagIt automatically captures at the timed intervals you specify using the options currently set.
- To stop the timed capture sequence you have started, select Stop on the SnagIt toolbar or use the hotkeys.
Shutting Down the Capture TimerTo shut down an active timed capture, do one of the following:
http://www.techsmith.com/ |
You are reading help file online using chmlib.com
|